行业动态
流片信息
知识园地
IP目录
10bit 60M pipeline ADC是一个高速、高精度、低功耗的ADC。本设计应用全差分多级pipeline结构,并且加入了数字校正电路。核心部分也包括了输出缓冲buffer和内部的带隙基准源,输出10位数字码是二进制模式。本ADC使用SMIC 28nm CMOS工艺,是全差分结构、可调参考电流的高度集成混合信号系统。
The 10Bit 300MSPS DAC is a triple high speed, digital-to-analog converter on a single monolithic chip.
本IP为串行解串模块(SerDes,Serializer/Deserializer),可以将20bit并行数据串化发送到信道上,同时可以接收信道上的串行数据然后转为20bit并行数据。其单通道速率为5Gbps,参考时钟为100MHz。
This IP is an embedded temperature sensor, with high precision and low power consumption.
This IP is a high speed segmented 12bit SARADC, including binary scaled error compensation technique.
V-by-one is a leading solution for scalable, low power, embedded, device-to-display video transmission.
Innosilicon TS-ADC IP is a small-sized, low power analog to digital converter with built-in temperature sensor.
The Innosilicon Audio Codec is a 24-bit solution that supports both cap and capless outputs from mono up to 7.1 surround sound.
The Innosilicon Audio Codec is a 24-bit solution that supports both cap and capless outputs from mono up to 7.1 surround sound.
The Innosilicon Audio Codec is a 24-bit solution that supports both cap and capless outputs from mono up to 7.1 surround sound.
The INNOSILICON MIPI M-PHY transceiver is fully V1-00-00 spec . It supports both master and slave roles in HS Gear 1~3 and LS operation. The M-PHY uses the MIPI standard M-PORTs Protocol Interface to simplify controller integration and supports DigRFv4, S
The INNOSILICON MIPI D-PHY is V1.0 spec compliant and can combine either a high-speed transmitter or receiver with a low speed transceiver to support ULP, LP and HS operation.
The Innosilicon Multi-SERDES PHY is a highly configurable design that supports SATA3, PCIe2 and XAUI with full compliance. High data rates are accurately achieved through fully programmable TX drivers and auto-calibrated on-die terminations.
The Innosilicon eDP DP PHY is a highly reliable solution for your display interface requirements. It is fully compliant with DP 1.0 and eDP 1.3 standards, and capable of driving 2.7Gb/s per lane in configurations up to 4 lanes.
The Innosilicon low power, mixed signal HDMI-IPTM Transmitter provides a complete HDMI 2.0/1.5 standard compliant interface solution for delivering video and audio streams.
The Innosilicon low power, mixed signal HDMI-IPTM Transmitter provides a complete HDMI 2.0/1.4 standard compliant interface solution for delivering video and audio streams.
The INNOSILICON USB 3.0 PHY is fully spec compliant. Combining the efficiency of a mature, but compact, USB 2.0 PHY with a Super Speed PHY to provide 5Gb/s operation, this complete solution is the answer to your USB 3.0 needs.
The INNOSILICON USB 3.0 PHY is fully spec compliant. Combining the efficiency of a mature, but compact, USB 2.0 PHY with a Super Speed PHY to provide 5Gb/s operation, this complete solution is the answer to your USB 3.0 needs.
The INNOSILICON USB 2.0 OTG PHY is fully compliant with UTMI+ level 3 Rev 1.1 specification.
The INNOSILICON USB 2.0 OTG PHY is fully compliant with UTMI+ level 3 Rev 1.0 specification.